2011-2013 Land Cruiser · Service Manual Suspension

REASSEMBLY

Removal / installation · Vehicles built from Sep 2011


1. INSTALL NO. 1 HEIGHT CONTROL BOLT CUSHION
  1. Install the 3 bolt cushions and 3 bolt holders to the pump and motor.


2. INSTALL HEIGHT CONTROL RESERVOIR ASSEMBLY

  1. C176195
    Using a 5 mm hexagon wrench, install the reservoir with the 5 bolts.

    Torque:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }


3. INSTALL HEIGHT CONTROL COMPRESSOR BRACKET ASSEMBLY

  1. C176759
    Install the bracket with the 3 nuts.

    Torque:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }


4. CONNECT NO. 4 FRAME WIRE

  1. C176101
    Connect the 2 connectors, clamp and frame wire.


5. INSTALL HEIGHT CONTROL CAP TO RESERVOIR HOSE

  1. C175800
    Install the hose to the reservoir tank, and push the connector up to attach it.

  1. C176842E01
    Install the hose, 2 breather plugs and 3 clips to the reservoir hose.


6. INSTALL HEIGHT CONTROL HOSE ASSEMBLY

  1. C176107E01
    Install the hose to the reservoir and motor with the 2 clips.

  1. Connect the clamp to the reservoir.

  1. C175776E01
    Check that the direction of the hose clamp is as shown in the illustration.

← INSPECTION (from Sep 2011)INSTALLATION (from Sep 2011) →