2011-2013 Land Cruiser · Service Manual Vehicle Exterior

REMOVAL

Removal / installation · Vehicles built from Sep 2011

HINT:
  1. Use the same procedures for LHD and RHD vehicles.
  2. The procedures listed below are for LHD vehicles.


1. REMOVE NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION
  1. w/o Console Box Lid:

    1. Remove the No. 2 instrument panel finish panel cushion (Click here).

  1. w/ Cool Box:

    1. Remove the No. 2 instrument panel finish panel cushion (Click here).

  1. w/o Cool Box:

    1. Remove the No. 2 instrument panel finish panel cushion (Click here).


2. REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH
  1. w/o Console Box Lid:

    1. Remove the lower instrument panel pad sub-assembly LH (Click here).

  1. w/ Cool Box:

    1. Remove the lower instrument panel pad sub-assembly LH (Click here).

  1. w/o Cool Box:

    1. Remove the lower instrument panel pad sub-assembly LH (Click here).


3. REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH

E154744E04
  1. Place protective tape as shown in the illustration.

    Text in Illustration 
    *1
    Protective Tape

  1. Using a moulding remover, detach the 3 claws and remove the No. 1 instrument cluster finish panel garnish.


4. REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH
  1. Place protective tape as shown in the illustration.

  1. Using a moulding remover, detach the 2 claws and remove the No. 2 instrument cluster finish panel garnish.

    B291251E01

    Text in Illustration 
    *A
    w/ Entry and Start System
    *B
    w/o Entry and Start System
    *1
    Protective Tape
    -
    -


5. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Floor Under Cover)

B180655
  1. Remove the 2 screws.

  1. Detach the 3 claws.

  1. Disconnect the connectors and remove the No. 1 instrument panel under cover.


6. REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

B180295E02
  1. Using a screwdriver, detach the 2 claws and open the hole cover.

    HINT:
    Tape the screwdriver tip before use.

    Text in Illustration 
    *1
    Protective Tape

  1. w/ Driver Side Knee Airbag:

    1. Remove the 2 bolts.

    2. Detach the 16 claws.

      B291249

  1. w/o Driver Side Knee Airbag:

    1. Remove the 2 bolts.

    2. Detach the 9 claws.

      B291250

  1. B180296
    for Automatic Air Conditioning System:

    1. Detach the 2 claws and remove the room temperature sensor.

  1. B181942
    Detach the 2 claws and disconnect the 2 control cables.

  1. Disconnect the connectors and remove the lower No. 1 instrument panel finish panel.


7. REMOVE NO. 1 SWITCH HOLE BASE

B180298
  1. Detach the 4 claws.

  1. Disconnect the connectors and remove the No. 1 switch hole cover.


8. REMOVE HEADLIGHT CLEANER SWITCH ASSEMBLY

  1. E156027
    Detach the 2 claws and remove the switch.

← COMPONENTS (from Sep 2011)INSPECTION (from Sep 2011) →