2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

INSTALLATION

Removal / installation · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


1. INSTALL HEADPHONE TERMINAL

  1. B182272
    Attach the 4 claws to install the headphone terminal.

  1. B182273E01
    Install the 2 screws.

  1. Attach the connector clamp.


2. INSTALL REAR CONSOLE END PANEL SUB-ASSEMBLY

  1. B182503
    Connect the connectors and 2 clamps.

  1. Attach the 8 claws to install the end panel.


3. INSTALL NO. 1 STEREO JACK ADAPTER ASSEMBLY

  1. B182275
    Attach the 2 claws to install the stereo jack adapter.


4. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY

  1. B180011
    Connect the connectors.

  1. Attach the 14 claws to install the console panel.


5. INSTALL CONSOLE CUP HOLDER BOX SUB-ASSEMBLY

  1. B180010
    Attach the 4 claws to install the box.


6. INSTALL REAR UPPER CONSOLE PANEL SUB-ASSEMBLY

  1. B180009
    Attach the 9 claws to install the panel.


7. INSTALL LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

  1. B180006
    Connect the connectors.

  1. Attach the 7 claws to install the panel.


8. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY

  1. Install the shift lever knob and twist it in the direction indicated by the arrow.

    B186291E01


9. INSTALL LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH

  1. B180005
    Attach the 7 claws to install the panel pad.

  1. Install the screw.

  1. Install the clip.


10. INSTALL NO. 1 INSTRUMENT PANEL FINISH PANEL CUSHION

  1. B182501
    Attach the 7 claws to install the panel cushion.


11. INSTALL LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH

  1. B181910
    Connect the connectors and 2 clamps.

  1. Attach the 8 claws to install the panel pad.

  1. Install the screw.

  1. Install the clip.


12. INSTALL NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION

  1. E155134
    Attach the 7 claws to install the panel cushion.


13. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

← INSTALLATION (Sep 2011 – Dec 2011)COMPONENTS (from Sep 2011) →