2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

REMOVAL

Removal / installation · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


2. REMOVE REAR NO. 1 SEAT ASSEMBLY RH (for 60/40 Split Seat Type 40 Side)
(Click here)

3. REMOVE REAR NO. 1 SEAT ASSEMBLY LH (for 60/40 Split Seat Type 60 Side)
(Click here)

4. REMOVE REAR NO. 2 SEAT ASSEMBLY
  1. for Face to Face Seat Type:
    Remove the rear No. 2 seat assembly (Click here).

  1. except Face to Face Seat Type:
    Remove the rear No. 2 seat assembly (Click here).


5. REMOVE REAR FLOOR MAT ASSEMBLY

A181487
  1. Detach the 5 clips and fold back the floor mat toward the front of the vehicle.

    HINT:
    Fold back the floor mat so that the rear No. 7 air duct can be removed.


6. REMOVE REAR NO. 7 AIR DUCT

  1. A176392
    Detach the 4 clips and remove the air duct.


7. REMOVE REAR FLOOR SERVICE HOLE COVER

A176326

8. REMOVE FUEL SENDER GAUGE ASSEMBLY

  1. A176327
    Disconnect the sender gauge connector.

  1. Remove the 5 screws and sender gauge.

    NOTICE:
    Be careful not to bend the arm of the fuel sender gauge.

  1. Remove the gasket from the sender gauge.

← COMPONENTS (from Sep 2011)REMOVAL (from Jan 2012) →