2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

REMOVAL

Removal / installation · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


1. PRECAUTION

NOTICE:
After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).


2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


3. REMOVE REAR NO. 1 SEAT ASSEMBLY RH (for 60/40 Split Seat Type 40 Side)
(Click here)

4. REMOVE REAR NO. 1 SEAT ASSEMBLY LH (for 60/40 Split Seat Type 60 Side)
(Click here)

5. REMOVE REAR NO. 2 SEAT ASSEMBLY
  1. for Face to Face Seat Type:
    Remove the rear No. 2 seat assembly (Click here).

  1. except Face to Face Seat Type:
    Remove the rear No. 2 seat assembly (Click here).


6. REMOVE REAR FLOOR MAT ASSEMBLY

A181487
  1. Detach the 5 clips and fold back the floor mat toward the front of the vehicle.

    HINT:
    Fold back the floor mat so that the rear No. 7 air duct can be removed.


7. REMOVE REAR NO. 7 AIR DUCT

  1. A176392
    Detach the 4 clips and remove the air duct.


8. REMOVE REAR FLOOR SERVICE HOLE COVER

A176326

9. REMOVE FUEL SENDER GAUGE ASSEMBLY

  1. A176327
    Disconnect the sender gauge connector.

  1. Remove the 5 screws and sender gauge.

    NOTICE:
    Be careful not to bend the arm of the fuel sender gauge.

  1. Remove the gasket from the sender gauge.

← REMOVAL (Sep 2011 – Dec 2011)INSPECTION (from Sep 2011) →