C1792 Height Control Switch Circuit (Test Mode DTC)
Diagnostic trouble codes · Vehicles built from Jan 2012
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
DESCRIPTION
This circuit sends a signal to the suspension control ECU in order to adjust the height to the selected height by the height control switch.| DTC Code |
Detection Condition |
Trouble Area |
| C1792 |
The test mode procedure is performed. |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- Before performing troubleshooting, inspect the connectors of related circuits.
- If the suspension control ECU or height control sensor is replaced, the vehicle height offset calibration must be performed (Click here).
- Before performing troubleshooting, inspect the connectors of related circuits.
| 1. READ VALUE USING INTELLIGENT TESTER (HEIGHT CONTROL SWITCH (UP), HEIGHT CONTROL SWITCH (DOWN)) |
Turn the engine switch off.
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG) and the tester on.
Enter the following menus: Chassis / AHC / Data List.
According to the display on the tester, read the Data List.
AHC Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Height Control Switch(Up)
Height control switch (Up) /
ON or OFF
ON: Up button of the height control switch is pushed.
OFF: Height control switch is not pushed.
-
Height Control Switch(Down)
Height control switch (Down) /
ON or OFF
ON: Down button of the height control switch is pushed.
OFF: Height control switch is not pushed.
-
- OK:
- On the tester screen, item changes between ON and OFF according to switch operation.
|
|
||||
| OK | |
| 2. TEST MODE INSPECTION |
Refer to the Test Mode Procedure and perform the signal check. Check that test mode DTC C1792 is cleared (Click here).
Result Result
Proceed to
DTC C1792 is not cleared
A
DTC C1792 is cleared
B
|
|
||||
| A | ||
| ||
| 3. INSPECT SUSPENSION CONTROL SWITCH (HEIGHT CONTROL SWITCH) |
Remove the suspension control switch (Click here).
Measure the resistance according to the value(s) in the table below.

- Standard Resistance:
Tester Connection
Switch Condition
Specified Condition
8 (LO) - 16 (E)
Down button of the height control switch is pushed.
Below 1 Ω
Height control switch is not pushed or the up button is pushed.
10 kΩ or higher
7 (HI) - 16 (E)
Up button of the height control switch is pushed.
Below 1 Ω
Height control switch is not pushed or the down button is pushed.
10 kΩ or higher
|
|
||||
| OK | |
| 4. CHECK HARNESS AND CONNECTOR (SUSPENSION CONTROL ECU - SWITCH AND BODY GROUND) |


Disconnect the K34 ECU connector.
Disconnect the V4 switch connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
K34-20 (UPSW) - V4-7 (HI)
Always
Below 1 Ω
K34-20 (UPSW) - Body ground
Always
10 kΩ or higher
K34-21 (DNSW) - V4-8 (LO)
Always
Below 1 Ω
K34-21 (DNSW) - Body ground
Always
10 kΩ or higher
V4-16 (E) - Body ground
Always
Below 1 Ω
|
|
||||
| OK | ||
| ||
