2011-2013 Land Cruiser · Service Manual Vehicle Interior

Security Horn Circuit

Circuit diagnosis · Vehicles built from Sep 2011

DESCRIPTION

When the theft deterrent system is operating, the certification ECU (smart key ECU assembly) outputs a signal continuously at 0.4 second intervals, causing the security horn to sound.

WIRING DIAGRAM

B184350E01

INSPECTION PROCEDURE


1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (SECURITY HORN)
  1. Operate the intelligent tester according to the steps on the display and select "Active Test".

    Entry&Start 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Security Horn
    Security horn
    ON/OFF
    -

    OK:
    Security horn operates normally.



NG
Go to step 2
OK

REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)

2. INSPECT FUSE (SECURITY)
  1. Remove the SECURITY fuse from the engine room relay block.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    SECURITY fuse
    Always
    Below 1 Ω



NG
REPLACE FUSE
OK


3. INSPECT SECURITY RELAY

  1. E145692E01
    Remove the security relay from the engine room relay block.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Battery voltage is not applied to terminals 1 and 2
    10 kΩ or higher
    3 - 5
    Battery voltage is applied to terminals 1 and 2
    Below 1 Ω



NG
REPLACE SECURITY RELAY
OK


4. INSPECT SECURITY HORN ASSEMBLY

  1. E140469E01
    Remove the security horn (Click here).

  1. Apply battery voltage to the horn connector and check the operation of the horn.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 1
    Battery negative (-) → Horn bracket
    Horn sounds



NG
REPLACE SECURITY HORN ASSEMBLY (Click here)
OK


5. CHECK HARNESS AND CONNECTOR (ENGINE ROOM RELAY BLOCK - CERTIFICATION ECU [SMART KEY ECU ASSEMBLY] AND SECURITY HORN)
B184351E01
  1. Remove the SECURITY relay from the engine room relay block.

  1. Disconnect the E30 ECU connector.

  1. Disconnect the A19 horn connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    Relay block security relay terminal 1 - E30-20 (SH-)
    Always
    Below 1 Ω
    Relay block security relay terminal 3 - A19-1
    Always
    Below 1 Ω
    E30-20 (SH-) Body ground
    Always
    10 kΩ or higher
    A19-1 - Body ground
    Always
    10 kΩ or higher

  1. Measure the voltage according to value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    Relay block security relay terminal 2 - Body ground
    Always
    11 to 14 V
    Relay block security relay terminal 5 - Body ground
    Always
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)


← Engine Hood Courtesy Switch Circuit (from Sep 2011)Intrusion Sensor Cancel Switch Circuit (from Sep 2011) →