2011-2013 Land Cruiser · Service Manual Vehicle Interior

Intrusion Sensor Cancel Switch Circuit

Circuit diagnosis · Vehicles built from Sep 2011

DESCRIPTION

  1. When the intrusion sensor cancel switch on the map light is pressed, the sensor off signal is sent to the certification ECU (smart key ECU assembly) which causes the intrusion sensor to stop operating.

WIRING DIAGRAM

B128933E03

INSPECTION PROCEDURE


1. READ VALUE USING INTELLIGENT TESTER (INTRUSION SENSOR CANCEL SWITCH)
  1. Using the intelligent tester, read the Data List.

    Entry&Start 
    Tester Display
    Measurement Item / Display (Range)
    Normal Condition
    Diagnostic Note
    Intrusion sensor OFF
    Intrusion sensor cancel switch /
    ON or OFF
    ON: Intrusion sensor active (switch off)
    OFF: Intrusion sensor not active (switch on)
    -

    OK:
    ON (intrusion sensor active [switch off]) appears on screen.



NG
Go to step 2
OK

REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)

2. CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU [SMART KEY ECU ASSEMBLY] - MAP LIGHT ASSEMBLY)
B188703E02
  1. Disconnect the E30 ECU connector.

  1. Disconnect the R7 light connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E30-5 (SSW1) - R7-11 (SOFF)
    Always
    Below 1 Ω
    E30-5 (SSW1) or R7-11 (SOFF) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK MAP LIGHT ASSEMBLY (INTRUSION SENSOR CANCEL SWITCH [OPERATION])
  1. Temporarily replace the map light assembly (intrusion sensor cancel switch) with a new or normally functioning one (Click here).

  1. Turn the intrusion sensor off by pressing the intrusion sensor cancel switch. Check if the switch operates normally by checking that the theft deterrent system does not operate when you move your hand in front of the sensor.

    OK:
    Intrusion sensor cancel switch operates normally.



NG
REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)
OK

END (MAP LIGHT [INTRUSION SENSOR CANCEL SWITCH] IS FAULTY)


← Security Horn Circuit (from Sep 2011)Theft Warning Siren Circuit (Sep 2011 – Dec 2011) →