2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

ECU Power Source Circuit

Circuit diagnosis · Vehicles built Sep 2011 – Dec 2011

DESCRIPTION

This circuit is the power source circuit to operate the parking assist ECU. The parking assist ECU controls the parking assist monitor system, side monitor system and Lexus parking assist-sensor system. When a malfunction occurs in this circuit, each system will be abnormal.

HINT:
  1. The parking assist ECU is connected to other ECUs via CAN communication or AVC-LAN communication.
  2. If the parking assist ECU does not operate due to a power source problem, a navigation system DTC may be stored due to an AVC-LAN communication interruption.
  3. If the parking assist ECU does not operate due to a power source problem, other system DTCs may be stored due to a CAN communication interruption.


WIRING DIAGRAM

E182726E32

INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.


1. CHECK HARNESS AND CONNECTOR (PARKING ASSIST ECU - BATTERY AND BODY GROUND)
  1. Disconnect the F43 connector from the parking assist ECU.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F43-4 (GND1) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    F43-6 (+B) - F43-4 (GND1)
    Always
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Image from Camera for Parking Assist Monitor is Abnormal (Sep 2011 – Dec 2011)PRECAUTION (from Jan 2012) →