2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

PROBLEM SYMPTOMS TABLE

Troubleshooting · Vehicles built Sep 2011 – Dec 2011

HINT:
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms the listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.

NOTICE:
The following inspection procedure of the parking assist monitor system is described on the assumption that the navigation system is normal. If navigation system has any malfunction, first proceed with troubleshooting of the navigation system.

General 
Symptom
Suspected Area
See page
When the shift lever is in R, the parking assist monitor image is not displayed (screen is not black).
ECU power source circuit
Click here
Images from all cameras are abnormal
Click here
Parking assist ECU
Click here
When the shift lever is in R, the parking assist monitor image is not displayed (screen is black).
Image from camera for parking assist monitor is abnormal
Click here
Display and navigation module display (for HDD)
Click here
Display and navigation module display (for DVD)
Click here
Parking assist ECU
Click here
When the shift lever is not in R, the parking assist monitor image is displayed.
Display and navigation module display (for HDD)
Click here
Display and navigation module display (for DVD)
Click here
Parking assist ECU
Click here
Display Malfunction 
Symptom
Suspected Area
See page
Image from camera for the parking assist monitor is abnormal.
Image from camera for parking assist monitor is abnormal
Click here
Images from all cameras are abnormal
Click here
Parking assist ECU
Click here
Parking Assist Monitor System Malfunction 
Symptom
Suspected Area
See page
Projected course guidelines are not displayed.
Parking assist ECU
Click here
"System initializing" is displayed.
Correct the steering angle neutral point
Click here
"System initializing" is displayed even after correcting the steering angle neutral point.
Spiral with sensor cable sub-assembly
Click here
Steering angle setting (Diagnosis System)
Click here
Parking assist ECU
Click here
"System not ready" is displayed.
Parking assist ECU initialization (Calibration)
Click here
"System not ready" is displayed even after parking assist ECU initialization.
Parking assist ECU
Click here
During parallel parking assist mode, the screen does not change even though the vehicle has moved.
If vehicle is reversing at very low speed, screen may not change
-
During parallel parking assist mode, the screen changes even though the vehicle has not moved.
If vehicle is stopped for extended period of time, screen may change
-
← CALIBRATION (Sep 2011 – Dec 2011)TERMINALS OF ECU (Sep 2011 – Dec 2011) →