2011-2013 Land Cruiser · Service Manual Suspension

INSPECTION

Inspection · Vehicles built from Sep 2011


INSPECT ACCELERATION SENSOR

C177935E03

NOTICE:
Do not drop the acceleration sensor. If it is dropped, replace it with a new one.

  1. Connect 3 dry batteries of 1.5 V in series.

  1. Connect the positive (+) end of the battery to terminal 3 (SGB) of the acceleration sensor and the negative (-) end of the battery to terminal 2 (SGG). Then measure the voltage between terminal 1 (SGFR*1, SGFL*2) and terminal 2 (SGG).

    HINT:
    *1: for RH
    *2: for LH

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    for RH 
    Tester Connection
    Condition
    Specified Condition
    1 (SGFR) - 2 (SGG)
    Sensor is stationary
    Approx. 2.0 to 2.5 V
    Sensor is tilted
    Change between approx. 0.9 to 2.3 V
    for LH 
    Tester Connection
    Condition
    Specified Condition
    1 (SGFL) - 2 (SGG)
    Sensor is stationary
    Approx. 2.0 to 2.5 V
    Sensor is tilted
    Change between approx. 0.9 to 2.3 V

    NOTICE:
    Do not apply a voltage of higher than 6 V.

    HINT:
    The voltage may differ according to the amount that the sensor is tilted.

    1. If the result is not as specified, replace the acceleration sensor.

← REMOVAL (from Sep 2011)INSTALLATION (from Sep 2011) →