2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

REPAIR

Removal / installation · Vehicles built Sep 2011 – Dec 2011

HINT:
  1. Bore all 8 cylinders to fit the O/S piston outside diameter.
  2. Replace all the piston rings with ones to match the O/S pistons.


1. BORE CYLINDER
  1. Prepare 4 new O/S pistons.

  1. A160815E01
    Using a micrometer, measure the piston diameter at a position that is 6.7 mm (0.264 in.) downward from the center of the piston pin hole.

    Standard piston diameter (O/S 0.50):
    94.468 to 94.496 mm (3.719 to 3.720 in.)

  1. Calculate the amount each cylinder is to be rebored as follows.

    HINT:
    1. Size to be rebored = P + C - H
      P = Piston diameter
      C = Piston oil clearance: 0.050 to 0.068 mm (0.00197 to 0.00268 in.)
      H = Allowance for honing: 0.02 mm (0.000787 in.) or less

  1. Bore and hone the cylinders to the calculated dimensions.

    NOTICE:
    Excess honing will destroy the finished roundness.

  1. Using a cylinder gauge, measure the cylinder bore diameter and calculate the honing allowance.

    HINT:
    Honing allowance = cylinder bore diameter - (piston diameter + oil clearance)

  1. Finish the cylinder bore using the calculated value.

  1. A005181E04
    Using a cylinder gauge, measure the cylinder bore diameter.

    Measurement Cylinder Bore Position:
    Position
    Specified Condition
    A
    10 mm (0.394 in.) from top edge
    B
    Center
    C
    10 mm (0.394 in.) from bottom edge

    Standard oil clearance:
    0.050 to 0.068 mm (0.00197 to 0.00268 in.)

    Maximum taper and out-of-round:
    0.02 mm (0.000787 in.)

    Maximum difference in diameter between each cylinder:
    0.05 mm (0.00197 in.)

← REASSEMBLY (Sep 2011 – Dec 2011)ON-VEHICLE INSPECTION (Sep 2011 – Dec 2011) →