2011-2013 Land Cruiser · Service Manual Power Source / Network

U0141 Lost Communication with Body Control Module "A"

Diagnostic trouble codes · Vehicles built from Jan 2012

DESCRIPTION

DTC Code
DTC Detection Condition
Trouble Area
U0141
There is no communication from the No. 2 main body ECU.
  1. Power source circuit of No. 2 main body ECU
  2. No. 2 main body ECU CAN branch wire or connector
  3. No. 2 main body ECU
  1. For vehicles with a power back door system.

WIRING DIAGRAM

C180679E03

INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

HINT:
Operating the ignition switch, any switches or any doors triggers related ECU and sensor communication with the CAN, which causes resistance variation.


1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).


NEXT


2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
  1. Disconnect the cable from the negative (-) battery terminal before measuring the resistances of the CAN main wire and the CAN branch wire.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    NOTICE:
    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


NEXT


3. CHECK FOR OPEN IN CAN BUS WIRE (NO. 2 MAIN BODY ECU CAN BRANCH WIRE)

  1. C251435E08
    Disconnect the L50 No. 2 main body ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    L50-11 (MPX+) - L50-12 (MPX-)
    Ignition switch off
    54 to 69 Ω

    Text in Illustration 
    *a
    Rear view of wire harness connector
    (to No. 2 Main Body ECU)



NG
REPAIR OR REPLACE NO. 2 MAIN BODY ECU CAN BRANCH WIRE OR CONNECTOR (MPX+, MPX-)
OK


4. CHECK HARNESS AND CONNECTOR (NO. 2 MAIN BODY ECU - BATTERY AND BODY GROUND)

  1. C251435E09
    Connect the cable to the negative (-) battery terminal.

    NOTICE:
    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    L50-14 (BECU) - Body ground
    Always
    11 to 14 V
    L50-13 (SIG) - Body ground
    Ignition switch ON
    11 to 14 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    L50-7 (GND) - Body ground
    Always
    Below 1 Ω

Text in Illustration 
*a
Rear view of wire harness connector
(to No. 2 Main Body ECU)


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE NO. 2 MAIN BODY ECU (Click here)


← U0132 Lost Communication with Suspension Control ECU (from Jan 2012)U0199 Lost Communication with "Door Control Module A" (Sep 2011 – Dec 2011) →