2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

P1616 Communication Error from ECM to Distance Control ECU

Diagnostic trouble codes · Vehicles built from Jan 2012

DESCRIPTION

The ECM sends the cruise control main switch signal, vehicle speed signal, etc. to the distance control ECU. The distance control ECU sends the acceleration signal, deceleration request signal, etc. to the ECM. The ECM controls cruise control according to these signals.
DTC Code
DTC Detection Condition
Trouble Area
P1616
The vehicle speed is 50 km/h (30 mph) or more with the cruise control main switch on (vehicle-to-vehicle distance control mode) and the data sent from the ECM to the distance control ECU is abnormal.
  1. Distance control ECU
  2. CAN communication system
  3. ECM

WIRING DIAGRAM

E149011E04

INSPECTION PROCEDURE

NOTICE:
When the distance control ECU is replaced with a new one, initialization must be performed (Click here).


1. REPLACE ECM
  1. for 1UR-FE:

    1. Replace the ECM with a new one (Click here).

  1. for 3UR-FE:

    1. Replace the ECM with a new one (Click here).


NEXT


2. CHECK DTC (DYNAMIC RADAR CRUISE CONTROL SYSTEM)
  1. Using the intelligent tester, enter the following menus: Powertrain / Radar Cruise / Trouble Code.

  1. Clear the DTCs (Click here).

  1. Perform the following to make sure the DTC detection conditions are met.

    HINT:
    If the detection conditions are not met, the system cannot detect the malfunction.

    1. Drive the vehicle at a speed of 50 km/h (30 mph) or more.

    2. Turn the cruise control main switch on to set the vehicle-to-vehicle distance control mode to the standby state.

  1. Check for DTCs (Click here).

    OK:
    DTC P1616 is not output.



NG
REPLACE DISTANCE CONTROL ECU (Click here)
OK

END


← P1615 Communication Error from Distance Control ECU to ECM (from Jan 2012)P1617 Distance Control ECU Malfunction (from Jan 2012) →