2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

Distance Control ECU Power Source Circuit

Circuit diagnosis · Vehicles built from Jan 2012

DESCRIPTION

This circuit provides power to operate the distance control ECU.

WIRING DIAGRAM

E158905E05

INSPECTION PROCEDURE


1. INSPECT FUSE (ECU-IG No. 3)
  1. Remove the ECU-IG No. 3 fuse from the cowl side junction block RH.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    ECU-IG No. 3 fuse
    Always
    Below 1 Ω



NG
REPLACE FUSE
OK


2. CHECK HARNESS AND CONNECTOR (DISTANCE CONTROL ECU - BATTERY AND BODY GROUND)

  1. E158904E02
    Disconnect the E108 distance control ECU connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    E108-1 (B) - Body ground
    Engine switch on (IG)
    11 to 14 V
    Engine switch off
    Below 1 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E108-12 (GND) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Cruise Control Switch Circuit (from Jan 2012)Millimeter Wave Radar Sensor Power Source Circuit (from Jan 2012) →