INSPECTION
Inspection · Vehicles built from Jan 2012
| INSPECT BACK DOOR CONTROL SWITCH |
Measure the resistance according to the value(s) in the table below.

- Standard Resistance:
Tester Connection
Switch Condition
Specified Condition
3 - 4
Pushed (on)
Below 1 Ω
3 - 4
Not pushed (off)
10 kΩ or higher
Apply battery voltage to the connector and check the LED illumination.
- OK:
Measurement Condition
Specified Condition
Battery positive (+) → terminal 2(ILL+)
Battery negative (-) → terminal 1(ILL-)
Illuminates
Text in Illustration *a
Component without harness connected
(Back Door Control Switch)
*b
Not pushed (off)
*c
Pushed (on)
