2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

B15DF USB Communication Malfunction

Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011

DESCRIPTION

This DTC is stored when a malfunction occurs in communication error with a USB device or "iPod".
DTC No.
DTC Detection Condition
Trouble Area
B15DF
When one of the conditions below is met:
  1. Communication error with USB device
  2. "iPod" control software of system microprocessor malfunction
  3. Communication error with "iPod"
  1. Multi-media interface ECU
  2. USB device or "iPod"

INSPECTION PROCEDURE

HINT:
After the inspection is completed, clear the DTCs.


1. REPLACE USB DEVICE OR "iPod"
  1. Disconnect the USB device or "iPod" from the No. 1 stereo jack adapter assembly.

  1. Turn the engine switch off.

    HINT:
    When this DTC has been stored, it is necessary to turn off the engine switch to make it possible for the vehicle to recognize a new device when it is connected.

  1. Turn the engine switch on (ACC).

  1. Connect a known good USB device or "iPod" to the No. 1 stereo jack adapter assembly.

HINT:
If the malfunction occurred when a USB device was in use, use another USB device for the inspection. If the malfunction occurred when an "iPod" was in use, use another "iPod" for the inspection.


NEXT


2. CLEAR DTC
  1. Clear the DTCs (Click here).


NEXT


3. RECHECK FOR DTC
  1. Recheck for DTCs.

    HINT:
    If DTCs are detected frequently, replace the multi-media interface ECU.

    OK:
    No DTC is output.



NG
REPLACE MULTI-MEDIA INTERFACE ECU (Click here)
OK

USB DEVICE OR "iPod" WAS DEFECTIVE


← B15D6 Display Disconnected (from Jan 2012)B15E1 Media Malfunction (Sep 2011 – Dec 2011) →