2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

B1585 USB Media Malfunction

Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011

DESCRIPTION

This DTC is stored when a malfunction occurs in a connected device.
DTC No.
DTC Detection Condition
Trouble Area
B1585
When one of the conditions below is met:
  1. Non mass-storage class or incompatible protocol USB device
  2. USB device with an incompatible file system, corrupted or incompatible File Allocation Table (FAT)
  3. "iPod" malfunction
  4. "iPod" with unsupported firmware
  5. Unsupported "iPod" model
  1. Multi-media interface ECU
  2. USB device or "iPod"

INSPECTION PROCEDURE

HINT:
After the inspection is completed, clear the DTCs.


1. REPLACE USB DEVICE OR "iPod"
  1. Disconnect the USB device or "iPod" from the No. 1 stereo jack adapter assembly.

  1. Turn the engine switch off.

    HINT:
    When this DTC has been stored, it is necessary to turn off the engine switch to make it possible for the vehicle to recognize a new device when it is connected.

  1. Turn the engine switch on (ACC).

  1. Connect a known good USB device or "iPod" to the No. 1 stereo jack adapter assembly.

HINT:
  1. If the malfunction occurred when a USB device was in use, use another USB device for the inspection. If the malfunction occurred when an "iPod" was in use, use another "iPod" for the inspection.
  2. Refer to System Description for compatible formats and versions (Click here).


NEXT


2. CLEAR DTC
  1. Clear the DTCs (Click here).


NEXT


3. CHECK DTC
  1. Recheck for DTCs.

    HINT:
    If DTCs are detected frequently, replace the multi-media interface ECU.

    OK:
    No DTC is output.



NG
REPLACE MULTI-MEDIA INTERFACE ECU (Click here)
OK

USB DEVICE FORMAT WAS INCOMPATIBLE, "iPod" VERSION WAS INCOMPATIBLE, OR USB DEVICE OR "iPod" WAS DEFECTIVE


← B1585 USB Device Malfunction (from Jan 2012)B15A1 Audio HU Malfunction (+ B15B3, B15B5, B15B7) (Sep 2011 – Dec 2011) →