2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

B15BB Multi-media Interface ECU Malfunction

Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011

DESCRIPTION

This DTC is stored when a malfunction occurs in the multi-media interface ECU.
DTC No.
DTC Detection Condition
Trouble Area
B15BB
When one of the conditions below is met:
  1. System microprocessor malfunction
  2. Media interface microprocessor malfunction
  3. CD-LSI (Large Scale Integration) malfunction
  4. Internal power supply malfunction
  1. USB device or "iPod"
  2. Wire harness or connector
  3. No. 1 stereo jack adapter assembly
  4. Multi-media interface ECU

WIRING DIAGRAM

E183263E47

INSPECTION PROCEDURE

HINT:
After the inspection is completed, clear the DTC.


1. REPLACE USB DEVICE OR "iPod"
  1. Disconnect the USB device or "iPod" from the No. 1 stereo jack adapter assembly.

  1. Turn the engine switch off.

    HINT:
    When this DTC has been stored, it is necessary to turn off the engine switch to make it possible for the vehicle to recognize a new device when it is connected.

  1. Turn the engine switch on (ACC).

  1. Connect a known good USB device or "iPod" to the No. 1 stereo jack adapter assembly.

HINT:
If the malfunction occurred when a USB device was in use, use another USB device for the inspection. If the malfunction occurred when an "iPod" was in use, use another "iPod" for the inspection.


NEXT


2. CLEAR DTC
  1. Clear the DTCs (Click here).


NEXT


3. RECHECK FOR DTC
  1. Recheck for DTCs and check if the same trouble occurs again.

    OK:
    No DTC is output.



NG
Go to step 4
OK

USB DEVICE OR "iPod" WAS DEFECTIVE

4. INSPECT MULTI-MEDIA INTERFACE ECU
  1. Disconnect the m1 No. 1 stereo jack adapter assembly connector.

  1. E194160E06
    Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    m1-1 (UPO) - m1-4 (UJSG)
    Always
    5 V

    Text in Illustration 
    *1
    Front view of wire harness connector
    (to No. 1 Stereo Jack Adapter Assembly)



NG
Go to step 5
OK

REPLACE NO. 1 STEREO JACK ADAPTER ASSEMBLY (Click here)

5. CHECK HARNESS AND CONNECTOR (INTERFACE ECU - STEREO JACK ADAPTER)
  1. Disconnect the L45 multi-media interface ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    L45-1 (UPO) - m1-1 (UPO)
    Always
    Below 1 Ω
    L45-4 (UESG) - m1-4 (UJSG)
    Always
    Below 1 Ω
    m1-1 (UPO) - Body ground
    Always
    10 kΩ or higher
    m1-4 (UJSG) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MULTI-MEDIA INTERFACE ECU (Click here)


← B15B8 Harddisk Malfunction (from Jan 2012)B15C2 Speed Signal Malfunction (from Jan 2012) →