2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

Display Signal Circuit between Radio Receiver and Television Display Assembly

Circuit diagnosis · Vehicles built from Jan 2012

DESCRIPTION

This is the display signal circuit from the multi-media module receiver assembly to the television display assembly.

WIRING DIAGRAM

E248576E02

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (MULTI-MEDIA MODULE RECEIVER ASSEMBLY - TELEVISION DISPLAY ASSEMBLY)
  1. Disconnect the F78 multi-media module receiver assembly connector.

  1. Disconnect the L53 television display assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F78-1 (NTSO) - L53-20 (NTS4)
    Always
    Below 1 Ω
    F78-2 (NTSG) - L53-19 (SGN4)
    Always
    Below 1 Ω
    F78-3 (SLD2) - L53-18 (SLD4)
    Always
    Below 1 Ω
    F78-1 (NTSO) - Body ground
    Always
    10 kΩ or higher
    F78-2 (NTSG) - Body ground
    Always
    10 kΩ or higher
    F78-3 (SLD2) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← DVD Image Signal Circuit between Radio Receiver and Navigation ECU (Sep 2011 – Dec 2011)Display Signal Circuit between Television Display Assembly and Navigation Receiver Assembly (Sep 2011 – Dec 2011) →