2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

Display Signal Circuit between Television Display Assembly and Navigation Receiver Assembly

Circuit diagnosis · Vehicles built Sep 2011 – Dec 2011

DESCRIPTION

This is the display signal circuit from the display and navigation module display to the television display assembly.

WIRING DIAGRAM

E192465E03

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (NAVIGATION ECU - TELEVISION DISPLAY)
  1. Disconnect the F66 display and navigation module display connector.

  1. Disconnect the L39 television display assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F66-4 (NTSO) - L39-23 (NTSC)
    Always
    Below 1 Ω
    F66-14 (SGND) - L39-22 (SGN1)
    Always
    Below 1 Ω
    F66-15 (SLD2) - L39-21 (SLD)
    Always
    Below 1 Ω
    F66-4 (NTSO) - Body ground
    Always
    10 kΩ or higher
    F66-14 (SGND) - Body ground
    Always
    10 kΩ or higher
    F66-15 (SLD2) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Display Signal Circuit between Radio Receiver and Television Display Assembly (from Jan 2012)Display Signal Circuit between Navigation ECU and Video Terminal (Sep 2011 – Dec 2011) →