2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

DVD Image Signal Circuit between Radio Receiver and Navigation ECU

Circuit diagnosis · Vehicles built Sep 2011 – Dec 2011

DESCRIPTION

This is the DVD image signal circuit from the radio receiver assembly to the display and navigation module display.

WIRING DIAGRAM

E181652E05

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - DISPLAY AND NAVIGATION MODULE DISPLAY)
  1. Disconnect the F56 radio receiver assembly connector.

  1. Disconnect the F66 display and navigation module display connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F56-8 (NTSC) - F66-9 (VV+)
    Always
    Below 1 Ω
    F56-22 (GND) - F66-20 (VV-)
    Always
    Below 1 Ω
    F56-8 (NTSC) - Body ground
    Always
    10 kΩ or higher
    F56-22 (GND) - Body ground
    Always
    10 kΩ or higher
    F56-7 (SLD) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Sound Signal Circuit between Headphone Terminal and Television Display (from Jan 2012)Display Signal Circuit between Radio Receiver and Television Display Assembly (from Jan 2012) →