B15F7 Certification ECU Vehicle Information Reading/Writing Process Malfunction
Diagnostic trouble codes · Vehicles built from Jan 2012
DESCRIPTION
This DTC is stored when items controlled by the certification ECU (smart key ECU assembly) cannot be customized via the audio and visual system vehicle customization screen.- HINT:
- The certification ECU (smart key ECU assembly) controls the entry and start system (for Entry Function) related items that are customizable via the multi-display assembly screen.
| DTC Code |
DTC Detection Condition |
Trouble Area |
| B15F7 |
Certification ECU (smart key ECU assembly) vehicle setting processing error. |
|
INSPECTION PROCEDURE
| 1. CHECK CAN COMMUNICATION SYSTEM |
Use the intelligent tester to check if the CAN communication system is functioning normally.
- for LHD (Click here)
- for RHD (Click here)
- OK:
- CAN communication DTCs are not output.
Result Result
Proceed to
OK
A
NG (for LHD)
B
NG (for RHD)
C
- for LHD (Click here)
|
|
||||
|
|
||||
| A | |
| 2. CHECK ENTRY AND START SYSTEM |
Check if the entry and start system is malfunctioning (Click here).
- HINT:
- Customization may not be possible depending on the malfunction in the entry and start system.
- OK:
- No malfunctions are present in the entry and start system.
|
|
||||
| OK | |
| 3. CHECK CUSTOMIZE ITEMS |
Display the "Vehicle Customization" screen.
Make a note of the customizable items for each certification ECU related system.
- HINT:
- These items shown as customizable via the multi-display assembly vehicle customization screen can also be changed using the intelligent tester. In a following step, the intelligent tester will be used.
Check the customize parameters list for the entry and start system related items that can be customized via the multi-display assembly screen (Click here).
Manually change and confirm that it was possible to successfully change the settings of the customize parameters for each system that are available for customization via the multi-display assembly screen.
- OK:
- The items available for customization via the multi-display assembly screen can be customized successfully using the manual procedure.
|
|
||||
| OK | ||
| ||
