B15F9 UART Communication Malfunction(for A/C)
Diagnostic trouble codes · Vehicles built from Jan 2012
DESCRIPTION
The multi-media module receiver assembly and multi-display assembly are connected by the UART communication line.When a UART communication error occurs between the multi-media module receiver assembly and multi-display assembly, these DTCs will be stored.
| DTC Code |
DTC Detection Condition |
Trouble Area |
| B15F9 |
Multi-display for air conditioning switch operation signal input malfunction. |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CLEAR DTC |
Clear the DTCs (Click here).
| NEXT | |
| 2. CHECK DTC |
Recheck for DTCs and check if the same DTC is output again (Click here).
- OK:
- No DTCs are output.
|
|
||||
| OK | ||
| ||
| 3. CHECK HARNESS AND CONNECTOR (MULTI-MEDIA MODULE RECEIVER ASSEMBLY - MULTI-DISPLAY ASSEMBLY) |
Disconnect the F77 multi-media module receiver assembly connector.
Disconnect the F79 multi-display assembly connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
F77-36 (UPSW) - F79-3 (UPSW)
Always
Below 1 Ω
F77-35 (UIND) - F79-4 (UIND)
Always
Below 1 Ω
F77-36 (UPSW) - Body ground
Always
10 kΩ or higher
F77-35 (UIND) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | |
| 4. REPLACE MULTI-DISPLAY ASSEMBLY |
Replace the multi-display assembly with a new or normally functioning one (Click here).
| NEXT | |
| 5. CLEAR DTC |
Clear the DTCs (Click here).
| NEXT | |
| 6. CHECK DTC |
Recheck for DTCs and check if the same DTC is output again (Click here).
- OK:
- No DTCs are output.
|
|
||||
| OK | ||
| ||
