"Back Door is Open" is Displayed even after Back Door is Closed
Circuit diagnosis · Vehicles built from Jan 2012
DESCRIPTION
The parking assist ECU receives back door lock assembly open/close signals from the main body ECU (cowl side junction block LH) via CAN communication. When the back door is open, the camera aiming cannot be adjusted correctly because the rear television camera assembly is installed on the back door. Therefore, when adjusting the camera aiming calibration while the back door is open, a back door open warning message will be displayed on the screen and camera aiming adjustment will be canceled.- HINT:
- The back door lock assembly is connected to the main body ECU (cowl side junction block LH) by the vehicle wire harness.
- The back door lock assembly is connected to the main body ECU (cowl side junction block LH) by the vehicle wire harness.
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- When "System initializing" is displayed on the parking assist ECU after the battery terminal disconnected, correct the steering angle neutral point (Click here).
- Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system (w/ Side Monitor System) may be needed (Click here).
- When "System initializing" is displayed on the parking assist ECU after the battery terminal disconnected, correct the steering angle neutral point (Click here).
| 1. READ VALUE USING INTELLIGENT TESTER (BACK DOOR COURTESY SWITCH) |
Use the Data List to check if the back door courtesy switch is functioning properly (Click here).
Main Body Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Back Door Courtesy SW
Back door courtesy light switch signal / ON or OFF
ON: Back door open
OFF: Back door closed
-
- OK:
- The back door courtesy switch functions as specified in the normal condition column.
|
|
||||
| OK | ||
| ||
| 2. CHECK HARNESS AND CONNECTOR (BACK DOOR LOCK ASSEMBLY - MAIN BODY ECU [COWL SIDE JUNCTION BLOCK LH] AND BODY GROUND) |
Disconnect the S1*1 or S22*2 back door lock assembly connector.
- *1: w/o Power Back Door System
- *2: w/ Power Back Door System
- *1: w/o Power Back Door System
Disconnect the E2 main body ECU (cowl side junction block LH) connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
- w/o Power Back Door System:
Tester Connection
Condition
Specified Condition
S1-3 (+) - E2-25 (BCTY)
Always
Below 1 Ω
S1-3 (+) - Body ground
Always
10 kΩ or higher
S1-1 (ACT-) - Body ground
Always
Below 1 Ω
- w/ Power Back Door System:
Tester Connection
Condition
Specified Condition
S22-3 (CTY) - E2-25 (BCTY)
Always
Below 1 Ω
S22-3 (CTY) - Body ground
Always
10 kΩ or higher
S22-4 (E) - Body ground
Always
Below 1 Ω
|
|
||||
| OK | |
| 3. INSPECT BACK DOOR LOCK ASSEMBLY |
Remove the back door lock assembly (Click here).
Inspect the back door lock assembly (Click here).
|
|
||||
| OK | ||
| ||
