2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

Display Signal Circuit between Multi-display and Radio Receiver

Circuit diagnosis · Vehicles built from Jan 2012

DESCRIPTION

The display image signal from the multi-media module receiver assembly is sent to the multi-display assembly using a GVIF cable.

WIRING DIAGRAM

E245680E14

INSPECTION PROCEDURE


1. CHECK GVIF CABLE CONNECTOR
  1. Check if the GVIF cable connector between the multi-media module receiver assembly and the multi-display assembly have any connection problems (Click here).

  1. Check that the screen display is normal.

    OK:
    Screen display is normal.



NG
Go to step 2
OK

USE SIMULATION METHOD TO CHECK (Click here)

2. CHECK MULTI-DISPLAY ASSEMBLY
  1. Replace the multi-display assembly (Click here).

  1. Check that the screen display is normal.

    OK:
    Screen display is normal.



NG
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
OK

END (MULTI-DISPLAY ASSEMBLY IS DEFECTIVE)


← Visual Mute Signal Circuit between Navigation ECU and Multi-display (from Jan 2012)Microphone Circuit between Microphone and Radio Receiver (from Jan 2012) →