2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

Visual Mute Signal Circuit between Navigation ECU and Multi-display

Circuit diagnosis · Vehicles built from Jan 2012

DESCRIPTION

The multi-media module receiver assembly sends a visual mute signal to the multi-display assembly. As a result, a black screen is inserted when the screen changes so that noise and distorted images are not displayed.
When an open exists in the circuit, noise and distorted images will be displayed instead of a black screen.
When a short exists in the circuit, even though the multi-display assembly is operating normally, noise and distorted images will be displayed (black screen will not be displayed) during screen changes or the black screen will always be displayed.

WIRING DIAGRAM

E245681E10

INSPECTION PROCEDURE


1. CHECK MULTI-MEDIA MODULE RECEIVER ASSEMBLY

  1. E239014E14
    Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    F77-10 (VMTF) - Body ground
    Engine switch on (ACC), screen display changes.
    3.5 V or higher → Below 1 V → 3.5 V or higher

    Text in Illustration 
    *a
    Component with harness connected
    (Multi-media Module Receiver Assembly)



NG
REPLACE MULTI-MEDIA MODULE RECEIVER ASSEMBLY (Click here)
OK


2. CHECK HARNESS AND CONNECTOR (MULTI-MEDIA MODULE RECEIVER ASSEMBLY - MULTI-DISPLAY ASSEMBLY)
  1. Disconnect the F79 multi-display assembly connector.

  1. Disconnect the F77 multi-media module receiver assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    F79-11 (VMTI) - F77-10 (VMTF)
    Always
    Below 1 Ω
    F79-11 (VMTI) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← AVC-LAN Circuit (from Jan 2012)Display Signal Circuit between Multi-display and Radio Receiver (from Jan 2012) →