2011-2013 Land Cruiser · Service Manual Brake

C1340 Center Differential Lock Circuit

Diagnostic trouble codes · Vehicles built from Jan 2012

DESCRIPTION

DTC Code
DTC Detection Condition
Trouble Area
C1340
An open circuit is detected in the EXI circuit of the skid control ECU.
  1. Harness or connector
  2. Transfer system
  3. Skid control ECU (Master cylinder solenoid)

WIRING DIAGRAM

C212548E10

INSPECTION PROCEDURE

NOTICE:
After replacing the master cylinder solenoid, perform zero point calibration and store the system information (Click here).


1. CHECK HARNESS AND CONNECTOR (EXI TERMINAL)
  1. Turn the ignition switch off.

  1. Disconnect the skid control ECU (master cylinder solenoid) connector.

  1. C214161E69
    Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    A24-27 (EXI) - Body ground
    Ignition switch ON
    11 to 14 V

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Skid Control ECU [Master Cylinder Solenoid])



NG
Go to step 3
OK


2. RECONFIRM DTC
  1. Clear the DTCs (Click here).

  1. Turn the ignition switch off.

  1. Check for DTCs (Click here).

    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output (for LHD)
    B
    DTC is output (for RHD)
    C



B
REPLACE MASTER CYLINDER SOLENOID (Click here)

C
REPLACE MASTER CYLINDER SOLENOID (Click here)
A

CHECK FOR INTERMITTENT PROBLEMS (Click here)

3. CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - 4 WHEEL DRIVE CONTROL ECU/TRANSFER SHIFT ACTUATOR)
  1. Disconnect the A24 skid control ECU (master cylinder solenoid) connector.

  1. Disconnect the A27 4 wheel drive control ECU connector.

  1. Disconnect the C37 transfer shift actuator assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A24-27 (EXI) - A27-14 (P1)
    Always
    Below 1 Ω
    A24-27 (EXI) - C37-3 (CDL)
    Always
    Below 1 Ω
    A24-27 (EXI) - Body ground
    Always
    10 kΩ or higher
    C37-7 (GND1) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

GO TO TRANSFER SYSTEM (PROBLEM SYMPTOMS TABLE) (Click here)


← C1337/37 Diameter of the Tire is not Uniform (Sep 2011 – Dec 2011)C1340/47 Center Differential Lock Circuit (Sep 2011 – Dec 2011) →