C1409 Front Speed Sensor RH Performance
Diagnostic trouble codes · Vehicles built from Jan 2012
Also covers:
- C1410 Front Speed Sensor LH Performance
DESCRIPTION
Refer to DTCs C1401 and C1402 (Click here).| DTC Code |
DTC Detection Condition |
Trouble Area |
| C1409 C1410 |
One of the following conditions is met:
|
Front speed sensor RH/LH |
- HINT:
- DTC C1409 is for the front speed sensor RH.
- DTC C1410 is for the front speed sensor LH.
- DTC C1409 is for the front speed sensor RH.
INSPECTION PROCEDURE
- NOTICE:
- Check the speed sensor signal after replacement (Click here).
| 1. READ VALUE USING GTS (FR/FL WHEEL SPEED) |
Turn the ignition switch off.
Connect the GTS to the DLC3.
Start the engine.
Turn the GTS on.
Enter the following menus: Chassis / ABS/VSC/TRC / Data List.
ABS/VSC/TRC Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
FR Wheel Speed
Front speed sensor RH reading/ Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph)
Actual wheel speed
No large fluctuations when driving at a constant speed.
FL Wheel Speed
Front speed sensor LH reading/ Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph)
Actual wheel speed
No large fluctuations when driving at a constant speed.
Check that there is no difference between the speed value output from the speed sensor displayed on the GTS and the speed value displayed on the speedometer when driving the vehicle.
- HINT:
- Factors that affect the indicated vehicle speed include tire size, tire inflation and tire wear. The speed indicated on the speedometer has an allowable margin of error. This can be tested using a speedometer tester (calibrated chassis dynamometer). For details about testing and the margin of error, refer to the reference chart (Click here).
- OK:
- The speed value output from the speed sensor displayed on the GTS is the same as the actual vehicle speed measured using a speedometer tester (calibrated chassis dynamometer).
|
|
||||
| OK | |
| 2. READ VALUE USING GTS (FR/FL WHEEL DIRECTION) |
Turn the ignition switch off.
Connect the GTS to the DLC3.
Start the engine.
Turn the GTS on.
Enter the following menus: Chassis / ABS/VSC/TRC / Data List.
ABS/VSC/TRC Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
FR Wheel Direction
Front wheel direction RH/ Forward or Back
Forward: Forward
Back: Back
-
FL Wheel Direction
Front wheel direction LH/ Forward or Back
Forward: Forward
Back: Back
-
Check the "FR/FL Wheel Direction" in the Data List both when the vehicle is being driven straight forward at a speed of 30 km/h (19 mph) or more and when the vehicle is being driven in reverse at a speed of 3 km/h (2 mph) or more.
- OK:
- The sensor signal matches wheel direction.
|
|
||||
| OK | |
| 3. RECONFIRM DTC |
Clear the DTC (Click here).
Turn the ignition switch off.
Start the engine.
Perform a road test.
Check if the same DTC is output (Click here).
Result Result
Proceed to
DTC C1409 or C1410 is output
A
DTC is not output
B
|
|
||||
| A | ||
| ||
