C1452 Accumulator Low Pressure
Diagnostic trouble codes · Vehicles built from Jan 2012
DESCRIPTION
| DTC Code |
DTC Detection Condition |
Trouble Area |
| C1452 |
After braking, the fluid pressure inside the accumulator is less than the threshold within 3.2 seconds. |
|
INSPECTION PROCEDURE
- NOTICE:
- After replacing the master cylinder solenoid, perform zero point calibration (Click here).
| 1. CUSTOMER PROBLEM ANALYSIS |
Check with the customer to determine if frequent braking has been performed.
| NEXT | |
| 2. RECONFIRM DTC |
Clear the DTC (Click here).
Turn the ignition switch off.
Depress the brake pedal more than 40 times.
Turn the ignition switch to ON.
Wait for 99 seconds.
Check if the same DTC is output (Click here).
Result Result
Proceed to
DTC is output
A
Frequent braking was not performed and DTC is not output
B
Frequent braking was performed and DTC is not output
C
- HINT:
- Excessive brake pedal operation results in abnormal accumulator pressure consumption. This is normal.
|
|
||||
|
|
||||
| A | |
| 3. CHECK HYDRAULIC CIRCUIT |
Check the hydraulic circuit (Click here).
- OK:
- Hydraulic circuit is normal (no leakage).
|
|
||||
| OK | |
| 4. READ VALUE USING GTS (ACCUMULATOR SENSOR) |
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Chassis / ABS/VSC/TRC / Data List.
| Tester Display |
Measurement Item/Range |
Normal Condition |
Diagnostic Note |
| Accumulator Sensor |
Accumulator pressure sensor reading/ Min.: 0.00 V, Max.: 5.00 V |
3.58 to 5 V |
If the value is constant regardless of the pump operation, an accumulator pressure sensor malfunction is suspected. |
Check that the accumulator output value is normal.
- OK:
- Accumulator pressure sensor value is normal.
Result Result
Proceed to
OK
A
NG (for LHD)
B
NG (for RHD)
C
|
|
||||
|
|
||||
| A | |
| 5. RECONFIRM DTC |
Clear the DTCs (Click here).
Turn the ignition switch off.
Check if the same DTC is output (Click here).
Result Result
Proceed to
DTC is not output
A
DTC is output (for LHD)
B
DTC is output (for RHD)
C
|
|
||||
|
|
||||
| A | ||
| ||
