C1691 Back Camera Initialization Incomplete
Diagnostic trouble codes · Vehicles built from Jan 2012
SYSTEM DESCRIPTION
This DTC is stored when the multi-media module receiver assembly judges that the back camera initial setting has not been memorized (rear television camera optical axis adjustment is incomplete).| DTC Code |
DTC Detection Condition |
Trouble Area |
| C1691 |
Back camera initial setting has not been memorized |
|
INSPECTION PROCEDURE
- NOTICE:
- When "System initializing" is displayed on the multi-media module receiver assembly after disconnecting the cable from the negative (-) battery terminal, correct the steering angle neutral point (Click here).
- Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system (w/o Side Monitor System) may be needed (Click here).
- When "System initializing" is displayed on the multi-media module receiver assembly after disconnecting the cable from the negative (-) battery terminal, correct the steering angle neutral point (Click here).
| 1. ADJUST SETTINGS |
Perform the following procedure depending on the memory conditions to register the vehicle information into the multi-media module receiver assembly.
Rear television camera optical axis adjustment (Click here).
| NEXT | |
| 2. CHECK FOR DTC |
Clear the DTCs (Click here).
Check for DTCs (Click here).
- OK:
- DTC C1691 is not output.
- HINT:
- If DTC C1691 is output, perform the rear television camera assembly optical axis adjustment again.
- If DTC C1691 is still output after performing the rear television camera assembly optical axis adjustment 3 times, replace the multi-media module receiver assembly.
- If DTC C1691 is output, perform the rear television camera assembly optical axis adjustment again.
|
|
||||
| OK | ||
| ||
