Home › Engine / Hybrid System › 1UR-FE (ENGINE CONTROL) › AIR FUEL RATIO SENSOR › 2014.08–2015.08
RM2660E _51 Engine / Hybrid System _052772 1UR-FE ENGINE CONTROL _0254979 AIR FUEL RATIO SENSOR A

1UR-FE ENGINE CONTROL  AIR FUEL RATIO SENSOR  INSTALLATION  


PROCEDURE

Hide 89467B 1.INSTALL AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1)

a.

Temporarily install the air fuel ratio sensor to the exhaust manifold RH by hand.


b.
A218735E01
1.859,0.675 2.019,0.832 0.161,0.157 10 *1 1.565,2.216 1.869,2.360 0.304,0.144 10 SST 2.562,2.042 2.055,2.301 2.055,2.301 1.922,2.301 false

Using SST, tighten the air fuel ratio sensor.

SST
09224-00010  

Torque:
without SST : 44 N*m (449 kgf*cm, 32 ft.*lbf)
with SST : 40 N*m (408 kgf*cm, 30 ft.*lbf)

Text in Illustration
*1 Fulcrum Length

HINT:
·

Use a torque wrench with a fulcrum length of 300 mm (11.8 in.). When using a torque wrench with a fulcrum length that is not 300 mm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).

·

Make sure SST and the wrench are connected in a straight line.




Hide 89467B 2.INSTALL AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1)

a.

Temporarily install the air fuel ratio sensor to the exhaust manifold LH by hand.


b.
A218737E01
1.394,0.719 1.564,0.868 0.170,0.149 10 *1 1.769,2.219 2.078,2.369 0.309,0.150 10 SST 0.876,2.028 1.619,2.3 1.619,2.3 1.76,2.3 false

Using SST, tighten the air fuel ratio sensor.

SST
09224-00010  

Torque:
without SST : 44 N*m (449 kgf*cm, 32 ft.*lbf)
with SST : 40 N*m (408 kgf*cm, 30 ft.*lbf)

Text in Illustration
*1 Fulcrum Length

HINT:
·

Use a torque wrench with a fulcrum length of 300 mm (11.8 in.). When using a torque wrench with a fulcrum length that is not 300 mm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).

·

Make sure SST and the wrench are connected in a straight line.




Hide 17150 3.INSTALL EXHAUST MANIFOLD ASSEMBLY