Home › Engine / Hybrid System › 1VD-FTV (ENGINE CONTROL) › ECD SYSTEM (w/o DPF) › 2014.08–2015.08
RM2660E _51 Engine / Hybrid System _052773 1VD-FTV ENGINE CONTROL _0254984 ECD SYSTEM(w/o DPF) C

1VD-FTV ENGINE CONTROL  ECD SYSTEM(w/o DPF)  U0101  Lost Communication with TCM  


DESCRIPTION

The engine control unit and the transmission control unit are located inside the ECM. The engine control unit intercommunicates with the transmission control unit with the Controller Area Network (CAN). If there is a problem in this intercommunication, the ECM stores a DTC.

DTC Code DTC Detection Condition Trouble Area
U0101 No communication with the ECM continues. ECM

PROCEDURE

1.CHECK DTC OUTPUT (IN ADDITION TO DTC P0101)
a.

Connect the intelligent tester to the DLC3.


b.

Turn the engine switch on (IG).


c.

Turn the intelligent tester on.


d.

Enter the following menus: Powertrain / ECT / Trouble Codes.


e.

Read the DTCs using the tester.

Result
Result Proceed to
Only U0101 is output A
U0101 and other DTCs are output B

HINT:

If any other codes besides U0101 are output, perform troubleshooting for those DTCs first.




A

2.REPLACE ECM

B

2.REPLACE ECM

NEXT

3.CHECK IF DTC RECURS
3.CHECK IF DTC RECURS

b.

Start the engine.


c.

Read the DTCs using the tester.

Result
Result Proceed to
No DTC output A
Other DTCs output B



A

END

B