Home › Engine / Hybrid System › 1VD-FTV (ENGINE CONTROL) › INTAKE AIR TEMPERATURE SENSOR
RM2660E _51 Engine / Hybrid System _052773 1VD-FTV ENGINE CONTROL _0254989 INTAKE AIR TEMPERATURE SENSOR A

1VD-FTV ENGINE CONTROL  INTAKE AIR TEMPERATURE SENSOR  INSTALLATION  


PROCEDURE

Hide 89424D 1.INSTALL INTAKE AIR TEMPERATURE SENSOR (w/o Intercooler)

a.

Using a 22mm deep socket wrench, install the sensor and a new gasket.

Torque:
34 N*m (347 kgf*cm, 25 ft.*lbf)


Hide 89424D 2.INSTALL INTAKE AIR TEMPERATURE SENSOR (w/ Intercooler)

a.
A184228E02
1.375,1.677 2.427,1.875 1.052,0.198 10 false Fulcrum length

Using a ball joint lock nut wrench, install the sensor and a new gasket.

Torque:
29 N*m (300 kgf*cm, 22 ft.*lbf)

NOTICE:

Do not use a tool such as an impact wrench or equivalent.


HINT:
·

Use a torque wrench with a fulcrum length of 300 mm (11.8 in.). When using a torque wrench with a fulcrum length that is not 300 mm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).

·

Make sure SST and the wrench are connected in a straight line.




Hide 17940D 3.INSTALL INTERCOOLER ASSEMBLY (w/ Intercooler)