Home › Engine / Hybrid System › 1VD-FTV (ENGINE CONTROL) › POWER STEERING OIL PRESSURE SWITCH › from 2015.08
RM2660E _51 Engine / Hybrid System _052773 1VD-FTV ENGINE CONTROL _0254991 POWER STEERING OIL PRESSURE SWITCH G

1VD-FTV ENGINE CONTROL  POWER STEERING OIL PRESSURE SWITCH  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 89438B 1.INSPECT POWER STEERING OIL PRESSURE SWITCH

a.

Check the oil pressure switch.

i.

Connect the GTS to the DLC3.


ii.

Turn the ignition switch to ON.


iii.

Turn the GTS on.


iv.

Enter the following menus: Powertrain / Engine / Data List / Primary / Power Steering Signal.


v.

Start the engine.


vi.

Operate the steering wheel while idling, and read the value on the GTS.

OK:
Condition Specified Condition
Power steering operation ON
Power steering not operation OFF


If not as specified, check for DTCs (w/o DPF: See page Engine / Hybrid System>1VD-FTV (ENGINE CONTROL)>ECD SYSTEM (w/o DPF)>DIAGNOSIS SYSTEM, w/ DPF: Engine / Hybrid System>1VD-FTV (ENGINE CONTROL)>ECD SYSTEM (w/ DPF)>DIAGNOSIS SYSTEM). If the power steering system inspection results are normal and a DTC is not output, replace the power steering oil pressure switch.

Inspect the power steering system (See page Steering>POWER ASSIST SYSTEMS>VANE PUMP (for 1VD-FTV)>ON-VEHICLE INSPECTION). If the power steering system inspection results are normal and a DTC is not output, replace the power steering oil pressure switch.