Home › Engine / Hybrid System › 1VD-FTV (ENGINE CONTROL) › DIESEL THROTTLE BODY › from 2015.08
RM2660E _51 Engine / Hybrid System _052773 1VD-FTV ENGINE CONTROL _0254992 DIESEL THROTTLE BODY A

1VD-FTV ENGINE CONTROL  DIESEL THROTTLE BODY  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 17940D 3.REMOVE INTERCOOLER ASSEMBLY (w/ Intercooler)

Hide 4.REMOVE NO. 1 COOL AIR INLET (w/o Intercooler)

Hide 5.REMOVE NO. 2 COOL AIR INLET (w/o Intercooler)

Hide 12142 6.DISCONNECT NO. 2 ENGINE OIL LEVEL DIPSTICK GUIDE

a.
A176580

Remove the bolt and disconnect the oil level dipstick guide.


Hide 17971 7.REMOVE AIR TUBE SUB-ASSEMBLY RH

a.
A174729

Loosen the hose clamp.


b.

Remove the air tube from the throttle body.


Hide 8.DRAIN CLUTCH FLUID (for Manual Transmission)

Hide 31418 9.REMOVE CLUTCH HOSE (for Manual Transmission)

a.
A177028

Disconnect the 2 flexible hose tubes from the clutch hose with a 10 mm union nut wrench while holding the flexible hose with a wrench.

NOTICE:
·

Do not bend or damage the flexible hose tubes.

·

Do not allow any foreign matter such as dirt and dust to enter the flexible hose tubes from the connecting point.




b.

Remove the 2 clips.


c.
A183845

Remove the bolt and clutch hose.


Hide 17972 10.REMOVE AIR TUBE SUB-ASSEMBLY LH

a.
A174728

Loosen the hose clamp.


b.

Remove the air tube from the throttle body.


Hide 31489 11.REMOVE TUBE CONNECTOR TO FLEXIBLE HOSE TUBE (for Manual Transmission)

a.
A177030

Using a 10 mm union nut wrench, disconnect the tube connector to flexible hose tube from the clutch tube to release cylinder 2 way.

NOTICE:
·

Do not bend or damage the flexible hose tube.

·

Do not allow any foreign matter such as dirt and dust to enter the flexible hose tube from the connecting point.




b.
A177031

Remove the 2 bolts and tube connector to flexible hose tube.


Hide 26100G 12.REMOVE DIESEL THROTTLE BODY ASSEMBLY RH

a.
A163132

Disconnect the throttle position sensor connector.


b.

Disconnect the throttle motor connector.


c.

Remove the 2 bolts, 2 nuts and throttle body.


d.

Remove the gasket from the intake pipe.


Hide 13.REMOVE DIESEL THROTTLE BODY ASSEMBLY LH

a.
A163131

Disconnect the throttle position sensor connector.


b.

Disconnect the throttle motor connector.


c.

Remove the 2 bolts, 2 nuts and throttle body.


d.

Remove the gasket from the intake pipe.