Home › Engine / Hybrid System › 1GR-FE (ENGINE CONTROL) › SFI SYSTEM › from 2015.08
RM2660E _51 Engine / Hybrid System _052774 1GR-FE ENGINE CONTROL _0255001 SFI SYSTEM C

1GR-FE ENGINE CONTROL  SFI SYSTEM  P0116  Engine Coolant Temperature Circuit Range / Performance Problem  


DESCRIPTION

Refer to DTC P0115 (See page Engine / Hybrid System>1GR-FE (ENGINE CONTROL)>SFI SYSTEM>P0115).

DTC No. DTC Detection Condition Trouble Area
P0116 Either condition is met (2 trip detection logic):
·

When the engine is started cold and then warmed up, the engine coolant temperature sensor value does not change.

·

After the warmed up engine is stopped and the next cold engine start is performed, the engine coolant temperature sensor value does not change.


·

Water inlet with thermostat

·

Engine coolant temperature sensor



MONITOR DESCRIPTION

Engine coolant temperature sensor cold start monitor

When a cold engine start is performed and then the engine is warmed up, if the engine coolant temperature sensor value does not change, it is determined that a malfunction has occurred. If this is detected in 2 consecutive driving cycles, the MIL is illuminated and a DTC is stored.


Engine coolant temperature sensor soak monitor

If the engine coolant temperature sensor value does not change after the warmed up engine is stopped and then the next cold engine start is performed, it is determined that a malfunction has occurred. If this is detected in 2 consecutive driving cycles, the MIL is illuminated and a DTC is stored.



CAUTION / NOTICE / HINT

HINT:
·

If DTC P0115, P0117 or P0118 is stored simultaneously with DTC P0116, the engine coolant temperature sensor may have an open or short circuit. Troubleshoot those DTCs first.

·

Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data from the time the malfunction occurred.



PROCEDURE

1.CHECK FOR ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0116)
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.


e.

Read the DTCs.


Result
Result Proceed to
P0116 is output A
P0116 and other DTCs are output B


A

2.INSPECT WATER INLET WITH THERMOSTAT

B

2.INSPECT WATER INLET WITH THERMOSTAT
a.

Remove the water inlet with thermostat (See page Engine / Hybrid System>1GR-FE (COOLING)>THERMOSTAT>REMOVAL).


b.

Measure the valve opening temperature of the thermostat.

Standard value:

80°C to 84°C (176°F to 183°F)


HINT:

In addition to the above check, confirm that the valve is completely closed when the temperature is below the standard.



c.

Reinstall the water inlet with thermostat (See page Engine / Hybrid System>1GR-FE (COOLING)>THERMOSTAT>INSTALLATION).



OK

NG

REPLACE WATER INLET WITH THERMOSTAT