Home › Engine / Hybrid System › 1GR-FE (ENGINE CONTROL) › KNOCK SENSOR
RM2660E _51 Engine / Hybrid System _052774 1GR-FE ENGINE CONTROL _0255005 KNOCK SENSOR A

1GR-FE ENGINE CONTROL  KNOCK SENSOR  INSTALLATION  


PROCEDURE

Hide 1.INSTALL KNOCK SENSOR

a.
A385657E01
0.448,0.156 0.76,0.354 0.313,0.198 10 false *A 0.448,3.448 0.76,3.646 0.313,0.198 10 false *B 1.479,0.177 1.792,0.375 0.313,0.198 10 false *b 0.729,0.667 1.042,0.865 0.313,0.198 10 false *a 2.531,0.854 2.844,1.052 0.313,0.198 10 false *d 1.417,3.427 1.729,3.625 0.313,0.198 10 false *b 0.729,3.948 1.042,4.146 0.313,0.198 10 false *c 2.531,4.125 2.844,4.323 0.313,0.198 10 false *d

Install the 2 sensors with the 2 bolts as shown in the illustration.

Torque:
20 N*m (204 kgf*cm, 15 ft.*lbf)

Text in Illustration
*A for Bank 2
*B for Bank 1
*a Engine Rear
*b Top
*c Engine Front
*d 0 to 15°


b.

Connect the 2 sensor connectors.


Hide 16332 2.INSTALL NO. 1 WATER OUTLET PIPE

a.

Install the water outlet pipe with the 2 nuts and bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


b.

Attach the 3 wire harness clamps.


Hide 11101 3.INSTALL CYLINDER HEAD SUB-ASSEMBLY (for Bank 1)