Home › Engine / Hybrid System › 1GR-FE (ENGINE CONTROL) › AIR FUEL RATIO SENSOR › from 2015.08
RM2660E _51 Engine / Hybrid System _052774 1GR-FE ENGINE CONTROL _0255006 AIR FUEL RATIO SENSOR A

1GR-FE ENGINE CONTROL  AIR FUEL RATIO SENSOR  INSTALLATION  


PROCEDURE

Hide 89467B 1.INSTALL AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1)

a.
A223685E03
0.099,0.853 0.419,1.040 0.320,0.187 10 SST 2.002,0.434 2.196,0.628 0.194,0.194 10 *1 0.504,0.932 0.664,0.932 0.664,0.932 0.893,1.166 false

Using SST, install the air fuel ratio sensor.

SST
09224-00010  

Torque:
without SST : 44 N*m (449 kgf*cm, 32 ft.*lbf)
with SST : 40 N*m (408 kgf*cm, 30 ft.*lbf)

Text in Illustration
*1 Fulcrum Length

HINT:
·

Use a torque wrench with a fulcrum length of 300 mm (11.8 in.). When using a torque wrench with a fulcrum length that is not 300 mm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).

·

Make sure SST and the wrench are connected in a straight line.




Hide 89467B 2.INSTALL AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1)

a.
A223683E03
0.866,1.504 1.177,1.690 0.311,0.186 10 SST 1.256,1.588 1.475,1.588 1.475,1.588 2.014,1.264 false 1.183,0.396 1.348,0.566 0.165,0.170 10 *1

Using SST, install the air fuel ratio sensor.

SST
09224-00010  

Torque:
without SST : 44 N*m (449 kgf*cm, 32 ft.*lbf)
with SST : 40 N*m (408 kgf*cm, 30 ft.*lbf)

Text in Illustration
*1 Fulcrum Length

HINT:
·

Use a torque wrench with a fulcrum length of 300 mm (11.8 in.). When using a torque wrench with a fulcrum length that is not 300 mm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).

·

Make sure SST and the wrench are connected in a straight line.




Hide 3.INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY