89465
1.INSTALL HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)
Temporarily install the sensor to the exhaust pipe by hand.
Using SST, tighten the sensor.
Use a torque wrench with a fulcrum length of 30 cm (11.8 in.). If using a torque wrench with a length that is not 30 cm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
Make sure SST and the wrench are connected in a straight line.
Connect the sensor connector.
89465A
2.INSTALL HEATED OXYGEN SENSOR (for Bank 2 Sensor 2)
Temporarily install the sensor to the exhaust pipe by hand.
Using SST, tighten the sensor.
Use a torque wrench with a fulcrum length of 30 cm (11.8 in.). If using a torque wrench with a length that is not 30 cm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
Make sure SST and the wrench are connected in a straight line.
17450B
3.INSTALL FRONT NO. 2 EXHAUST PIPE ASSEMBLY
Install 2 new gaskets to the front No. 2 exhaust pipe.
Connect the front No. 2 exhaust pipe to the exhaust manifold LH with 2 new nuts.
Connect the front No. 2 exhaust pipe to the center exhaust pipe with the 2 bolts.
Connect the heated oxygen sensor connector.
Hook the wire harness to the bracket.
4.INSPECT FOR EXHAUST GAS LEAK