Home › Engine / Hybrid System › 3UR-FE (ENGINE CONTROL) › AIR FUEL RATIO SENSOR › 2014.08–2015.08
RM2660E _51 Engine / Hybrid System _052775 3UR-FE ENGINE CONTROL _0255028 AIR FUEL RATIO SENSOR A

3UR-FE ENGINE CONTROL  AIR FUEL RATIO SENSOR  INSTALLATION  


PROCEDURE

Hide 1.INSTALL AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1)

a.
A181604

Temporarily install the sensor to the exhaust pipe by hand.


b.
A168888E02
2.746,0.707 3.050,0.884 0.304,0.177 10 SST 2.256,0.779 2.68,0.779 false 1.072,1.304 1.286,1.488 0.214,0.184 10 *1

Using SST, tighten the sensor.

SST
09224-00010  

Torque:
without SST : 44 N*m (449 kgf*cm, 32 ft.*lbf)
with SST : 40 N*m (408 kgf*cm, 30 ft.*lbf)

Text in Illustration
*1 Fulcrum Length

HINT:
·

Use a torque wrench with a fulcrum length of 300 mm (11.8 in.). If using a torque wrench with a length that is not 300 mm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).

·

Make sure SST and the wrench are connected in a straight line.




Hide 89467B 2.INSTALL AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1)

a.

Temporarily install the sensor to the exhaust pipe by hand.


b.
A168888E02
2.746,0.707 3.050,0.884 0.304,0.177 10 SST 2.256,0.779 2.68,0.779 false 1.072,1.304 1.286,1.488 0.214,0.184 10 *1

Using SST, tighten the sensor.

SST
09224-00010  

Torque:
without SST : 44 N*m (449 kgf*cm, 32 ft.*lbf)
with SST : 40 N*m (408 kgf*cm, 30 ft.*lbf)

Text in Illustration
*1 Fulcrum Length

HINT:
·

Use a torque wrench with a fulcrum length of 300 mm (11.8 in.). If using a torque wrench with a length that is not 300 mm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).

·

Make sure SST and the wrench are connected in a straight line.




Hide 17105 3.INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY