The battery supplies electricity to the ECM even when the engine switch is off. This power allows the ECM to store data such as DTC history, freeze frame data and fuel trim values. If the battery voltage falls below a minimum level, the memory is cleared and the ECM determines that there is a malfunction in the power supply circuit. When the engine is next started, the ECM illuminates the MIL and stores the DTC.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| P0560 | An open in the ECM back up power source circuit (1 trip detection logic). | ·
Open in back up power source circuit ·
Battery ·
Battery terminals ·
EFI MAIN fuse ·
ECM |
If DTC P0560 is stored, the ECM does not store other DTCs or the data stored in the ECM is partly cleared.
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Read freeze frame data using the intelligent tester. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data from the time the malfunction occurred.
Check that the battery is not depleted (See page Power Source / Network>3UR-FE (BATTERY / CHARGING)>CHARGING SYSTEM>ON-VEHICLE INSPECTION).
Battery is not depleted.
OK
NG
Check that the battery terminals are not loose or corroded.
Battery terminals are not loose or corroded.
OK
NG
Disconnect the A38 ECM connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A38-1 (BATT) - Body ground | Always | 11 to 14 V |
OK
NG
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG) and turn the tester on.
Turn the engine switch off and turn the tester off.
Start the engine and turn the tester on.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Read DTCs.
| Result | Proceed to |
|---|---|
| P0560 is output | A |
| No DTC is output | B |
A
B