Home › Engine / Hybrid System › 3UR-FE (ENGINE MECHANICAL) › DRIVE BELT
RM2660E _51 Engine / Hybrid System _052777 3UR-FE ENGINE MECHANICAL _0255044 DRIVE BELT A

3UR-FE ENGINE MECHANICAL  DRIVE BELT  INSTALLATION  


PROCEDURE

Hide 16361A 1.INSTALL FAN AND GENERATOR V BELT

a.
A163771E10
0.5,1.677 0.104,0.917 0.104,0.917 0.406,0.917 false 1.375,1.26 1.531,0.229 1.531,0.229 1.698,0.229 false 2.719,1.115 2.99,0.656 2.99,0.656 2.781,0.656 false 1.271,3.042 1.448,3.042 1.448,3.042 1.073,1.813 false 0.958,2.719 1.167,2.719 1.167,2.719 0.948,2.281 false 1.74,2.99 1.74,2.813 1.74,2.813 1.958,2.125 false 2.51,2.656 2.51,2.479 2.51,2.479 3.021,2.25 false 0.438,0.833 0.75,1.031 0.313,0.198 10 false *1 1.76,0.156 2.073,0.354 0.313,0.198 10 false *2 2.594,0.573 2.906,0.771 0.313,0.198 10 false *3 2.177,1.333 2.49,1.531 0.313,0.198 10 false *4 0.781,2.646 1.094,2.844 0.313,0.198 10 false *5 1.094,2.948 1.406,3.146 0.313,0.198 10 false *6 1.656,3.052 1.969,3.25 0.313,0.198 10 false *7 2.427,2.688 2.74,2.885 0.313,0.198 10 false *8

Set the V belt onto every part.


b.

While turning the belt tensioner counterclockwise, remove the bar.

Text in Illustration
*1 Vane Pump
*2 Water Pump
*3 No. 1 Idler
*4 Fan
*5 Generator
*6 Belt Tensioner
*7 Crankshaft
*8 Cooler Compressor

NOTICE:

Make sure that the V belt is properly set to each pulley.



c.
B000540E14
0.563,0.229 0.729,0.429 0.165,0.200 10 *a 2.235,0.229 2.401,0.394 0.166,0.165 10 *b

After installing the belt, check that it fits properly in the ribbed grooves.

Text in Illustration
*a CORRECT
*b INCORRECT

HINT:

Make sure to check by hand that the belt has not slipped out of the grooves on the bottom of the pulley.



Hide 51405A 3.INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

Hide 53806 4.INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH

Hide 53805 5.INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH