Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT BUMPER(for Standard) › 2014.08–2015.08
RM2660E _59 Vehicle Exterior _052857 EXTERIOR PANELS / TRIM _0255835 FRONT BUMPER(for Standard) A

EXTERIOR PANELS / TRIM  FRONT BUMPER(for Standard)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:

A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).


PROCEDURE

Hide 52521 1.INSTALL FRONT UPPER CENTER BUMPER RETAINER

a.

Install the front upper center bumper retainer with the 3 bolts.


Hide 81110 3.INSTALL HEADLIGHT ASSEMBLY RH

HINT:

Use the same procedure described for the LH side.


Hide 52116A 4.INSTALL FRONT BUMPER SIDE SUPPORT LH

a.

Attach the 3 clips to install the front bumper side support LH.


b.

Install the 2 screws.


Hide 52115A 5.INSTALL FRONT BUMPER SIDE SUPPORT RH

HINT:

Use the same procedure described for the LH side.


Hide 52026B 6.INSTALL FRONT NO. 2 BUMPER EXTENSION SUB-ASSEMBLY LH

a.

Install the front No. 2 bumper extension sub-assembly LH with the 4 nuts.

Torque:
67 N*m (683 kgf*cm, 49 ft.*lbf)


Hide 52025B 7.INSTALL FRONT NO. 2 BUMPER EXTENSION SUB-ASSEMBLY RH

HINT:

Use the same procedure described for the LH side.


Hide 52021 8.INSTALL FRONT BUMPER REINFORCEMENT SUB-ASSEMBLY

a.

Install the front bumper reinforcement sub-assembly with the 6 nuts.

Torque:
71 N*m (724 kgf*cm, 52 ft.*lbf)


Hide 52611 9.INSTALL FRONT BUMPER ENERGY ABSORBER

a.

Install the front bumper energy absorber.


Hide 52119A 10.INSTALL FRONT BUMPER COVER

HINT:

For the front bumper cover with garnish, use the procedure described below.


a.
B232036

w/ Headlight Cleaner System:

Connect the headlight cleaner hose.


b.

w/ TOYOTA Parking Assist-sensor System or w/ Fog Light:

Connect the No. 4 engine room wire connector.


c.

Attach the 10 claws to install the front bumper cover.


d.

Install the 3 clips, 4 screws and 4 bolts.


e.

Using a T30 "TORX" socket, install the 6 screws.


Hide 53292A 12.INSTALL UPPER RADIATOR SUPPORT SEAL

Hide 53806 13.INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH

a.

Push in the clip to install the front fender splash shield sub-assembly LH.


b.

Install the 3 bolts and screw.


Hide 53805 14.INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

a.

Push in the clip to install the front fender splash shield sub-assembly RH.


b.

Install the 3 bolts and 2 screws.


Hide 15.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (for HID Headlight)

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 17.ADJUST FOG LIGHT AIMING (w/ Fog Light)

Hide 18.INSPECT TOYOTA PARKING ASSIST-SENSOR SYSTEM (w/ TOYOTA Parking Assist-sensor System)