Home › Engine / Hybrid System › 3UR-FE (ENGINE MECHANICAL) › REAR CRANKSHAFT OIL SEAL › 2014.08–2015.08
RM2660E _51 Engine / Hybrid System _052777 3UR-FE ENGINE MECHANICAL _0255048 REAR CRANKSHAFT OIL SEAL A

3UR-FE ENGINE MECHANICAL  REAR CRANKSHAFT OIL SEAL  INSTALLATION  


PROCEDURE

Hide 11381A 1.INSTALL REAR CRANKSHAFT OIL SEAL

a.

Apply MP grease to the lip of a new oil seal.


b.
A236991E01
0.511,0.737 0.829,1.019 0.318,0.283 10 SST 0.892,0.817 1.067,0.817 1.067,0.817 1.593,1.013 false

Using SST and a hammer, tap in the oil seal until its surface is flush with the rear oil seal retainer edge.

SST
09223-56010  

NOTICE:
·

Keep the lip free from foreign matter.

·

Do not tap on the oil seal at an angle.




Hide 32101 2.INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY

Hide 4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).