Home › Engine / Hybrid System › 1GR-FE (FUEL) › FUEL SENDER GAUGE ASSEMBLY (for Fuel Sub Tank) › 2014.08–2015.08
RM2660E _51 Engine / Hybrid System _052780 1GR-FE FUEL _0255082 FUEL SENDER GAUGE ASSEMBLY(for Fuel Sub Tank) A

1GR-FE FUEL  FUEL SENDER GAUGE ASSEMBLY(for Fuel Sub Tank)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 71300S 3.REMOVE REAR NO. 1 SEAT ASSEMBLY RH (for 60/40 Split Seat Type 40 Side)

Hide 71400S 4.REMOVE REAR NO. 1 SEAT ASSEMBLY LH (for 60/40 Split Seat Type 60 Side)

Hide 5.REMOVE REAR NO. 2 SEAT ASSEMBLY

Hide 62520P 6.REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY LH

Hide 62510P 7.REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY RH

Hide 58570C 8.REMOVE REAR FLOOR MAT ASSEMBLY

A176328

a.

w/ Rear Air Conditioning System:

Detach the 5 clips and fold back the floor mat toward the front of the vehicle.

HINT:

Fold back the floor mat so that the rear No. 7 air duct can be removed.



b.

w/o Rear Air Conditioning System:

Detach the 5 clips and fold back the floor mat toward the front of the vehicle.

HINT:

Fold back the floor mat so that the service hole cover can be removed.



Hide 87212L 9.REMOVE REAR NO. 7 AIR DUCT (w/ Rear Air Conditioning System)

a.
A176392

Detach the 4 clips and remove the air duct.


Hide 58325E 10.REMOVE REAR FLOOR SERVICE HOLE COVER

A176326

Hide 83320 11.REMOVE FUEL SENDER GAUGE ASSEMBLY

a.
A176327

Disconnect the sender gauge connector.


b.

Remove the 5 screws and sender gauge.

NOTICE:

Be careful not to bend the arm of the fuel sender gauge.



c.

Remove the gasket from the sender gauge.