1.DISCHARGE FUEL SYSTEM PRESSURE
2. PRECAUTION
After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
11209
4.REMOVE V-BANK COVER SUB-ASSEMBLY
17880
5.REMOVE AIR CLEANER HOSE ASSEMBLY
12601B
6.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY
Remove the No. 1 engine cover sub-assembly.
12613
7.REMOVE NO. 3 ENGINE COVER
Remove the No. 3 engine cover.
23902
8.DISCONNECT NO. 2 FUEL TUBE
Disconnect the No. 2 fuel tube from the fuel pressure regulator (See page Engine / Hybrid System>3UR-FE (FUEL)>FUEL SYSTEM>PRECAUTION).
23901
9.DISCONNECT NO. 1 FUEL TUBE
Disconnect the No. 1 fuel tube from the fuel delivery pipe RH (for metallic type) (See page Engine / Hybrid System>3UR-FE (FUEL)>FUEL SYSTEM>PRECAUTION).
| *A | RH Side |
LH Side:
Disconnect the No. 1 fuel tube from the fuel delivery pipe LH (See page Engine / Hybrid System>3UR-FE (FUEL)>FUEL SYSTEM>PRECAUTION).
| *A | LH Side |
23271H
10.DISCONNECT NO. 1 FUEL HOSE
Disconnect the No. 1 fuel hose from the fuel delivery pipe LH (See page Engine / Hybrid System>3UR-FE (FUEL)>FUEL SYSTEM>PRECAUTION).
23807
11.REMOVE FUEL DELIVERY PIPE SUB-ASSEMBLY RH
Disconnect the ventilation hose and No. 6 wire harness connector.
Remove the 2 bolts and fuel delivery pipe RH.
When removing the delivery pipe, hold the pipe by both ends and pull it straight upward.
Remove the 2 delivery pipe spacers and 4 insulators from the cylinder head RH.
23808
12.REMOVE FUEL DELIVERY PIPE SUB-ASSEMBLY LH
Disconnect the No. 7 wire harness connector.
Remove the 2 bolts and fuel delivery pipe LH.
When removing the delivery pipe, hold the pipe by both ends and pull it straight upward.
Remove the 2 delivery pipe spacers and 4 insulators from the cylinder head LH.
23250
13.REMOVE FUEL INJECTOR ASSEMBLY
Remove the fuel injector from the fuel delivery pipe, and then disconnect the injector connector.
For reinstallation, attach a tag or label to the injector shaft.
Remove the O-ring from the fuel injector.
| *1 | O-Ring |
Detach the 3 clamps and then remove the No. 6 wire harness from the delivery pipe RH.
| *A | Fuel Delivery Pipe RH |
Detach the 3 clamps and then remove the No. 7 wire harness from the delivery pipe LH.
| *A | Fuel Delivery Pipe LH |