Home › Engine / Hybrid System › 3UR-FE (FUEL) › FUEL SENDER GAUGE ASSEMBLY (for Fuel Sub Tank) › from 2015.08
RM2660E _51 Engine / Hybrid System _052781 3UR-FE FUEL _0255095 FUEL SENDER GAUGE ASSEMBLY(for Fuel Sub Tank) A

3UR-FE FUEL  FUEL SENDER GAUGE ASSEMBLY(for Fuel Sub Tank)  INSTALLATION  


PROCEDURE

Hide 83320B 1.INSTALL FUEL SENDER GAUGE ASSEMBLY

a.

Install a new gasket to the fuel sender gauge assembly.


b.

Install the fuel sender gauge assembly with the 5 screws.

Torque:
1.5 N*m (15 kgf*cm, 13 in.*lbf)

NOTICE:

Be careful not to bend the arm of the fuel sender gauge assembly.



c.

Connect the fuel sender gauge connector.


Hide 58325E 2.INSTALL REAR FLOOR SERVICE HOLE COVER

a.

Install the rear floor service hole cover with new butyl tape.


Hide 87212L 3.INSTALL REAR NO. 7 AIR DUCT

a.
U163059E01
2.469,1.365 2.590,1.510 0.121,0.145 10 4 1.375,1.548 1.496,1.693 0.121,0.145 10 3 0.796,1.42 0.917,1.566 0.121,0.145 10 1 2.86,1.071 2.981,1.217 0.121,0.145 10 2

Attach the 4 clips to install the rear No. 7air duct.

HINT:

Attach the clips in the order shown in the illustration.



Hide 58570C 4.INSTALL REAR FLOOR MAT ASSEMBLY

a.

Attach the 5 clips to install the rear floor mat assembly.


Hide 5.INSTALL REAR NO. 2 SEAT ASSEMBLY

Hide 71400S 6.INSTALL REAR NO. 1 SEAT ASSEMBLY LH (for 60/40 Split Seat Type 60 Side)

Hide 71300S 7.INSTALL REAR NO. 1 SEAT ASSEMBLY RH (for 60/40 Split Seat Type 40 Side)

Hide 8.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).