12204
1.INSTALL PCV VALVE SUB-ASSEMBLY
Apply a light coat of engine oil to the O-ring.
| *1 | O-ring |
When reusing the PCV valve, inspect the O-ring.
If the O-ring has scratches or cuts, replace the PCV valve.
Using a 22 mm ball joint lock nut wrench, install the PCV valve sub-assembly.
Use the formula to calculate special torque values for situations where a ball joint lock nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
12261
2.INSTALL PCV HOSE
Connect the PCV valve hose to the valve.
Secure the hose with the clamp.
| *a | Upper Side |
| *b | 5 to 10 mm (0.197 to 0.394 in.) |
Make sure the direction of the hose clamp is as shown in the illustration.
12613
3.INSTALL NO. 3 ENGINE COVER
Install the No. 3 engine cover.
|
Engine Front |
Position the No. 3 engine cover so that the arrow mark faces the front of the engine and install it.
12614
4.INSTALL NO. 4 ENGINE COVER
Install the No. 4 engine cover.
|
Engine Front |
Position the No. 4 engine cover so that the arrow mark faces the front of the engine and install it.
17111
5.INSTALL INTAKE MANIFOLD