Home › Engine / Hybrid System › 1VD-FTV (EMISSION CONTROL) › DIFFERENTIAL PRESSURE SENSOR(for DPF)
RM2660E _51 Engine / Hybrid System _052786 1VD-FTV EMISSION CONTROL _0255152 DIFFERENTIAL PRESSURE SENSOR(for DPF) G

1VD-FTV EMISSION CONTROL  DIFFERENTIAL PRESSURE SENSOR(for DPF)  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 89481B 1.CHECK DIFFERENTIAL PRESSURE SENSOR ASSEMBLY

a.

Connect the GTS to the DLC3.


b.

Turn the engine switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Powertrain / Engine and ECT / Data List / DPNR Differential Pressure.


e.

for Bank 1:

Disconnect the No. 1 air hose from the differential pressure sensor.


f.

for Bank 2:

Disconnect the No. 3 air hose from the differential pressure sensor.


g.

Using SST, apply pressure to the differential pressure sensor.

SST
09992-00242  

A271317E01
0.049,0.051 0.239,0.202 0.190,0.151 10 *A 3.943,0.051 4.133,0.202 0.190,0.151 10 *B

Text in Illustration
*A for Bank 1 *B for Bank 2
V100135

Pressure
V100136

Front of the Vehicle


h.

Check the pressure value of the sensor.

Standard pressure:

Approximately the same pressure as the applied pressure is indicated on the tester.


HINT:

Perform the inspection by applying a pressure within the range of 0 to 98 kPa (0 to 1.0 kgf/cm2, 0 to 14.2 psi).


If the result is not as specified, check the sensor circuit (See page Engine / Hybrid System>1VD-FTV (ENGINE CONTROL)>ECD SYSTEM (w/ DPF)>P2454).


i.

for Bank 1:

Connect the No. 1 air hose to the differential pressure sensor.


j.

for Bank 2:

Connect the No. 3 air hose to the differential pressure sensor.